An alarm delay can be set for a high, low or pre-alarm, and is the number of readings your logging device will wait after the alarm threshold is reached before activating the alarm. The delay count resets as soon as the reading goes back within the threshold. A good example of using an alarm delay is inside a fridge when you don’t want the alarm to activate every time the door is opened.
Normally, if an alarm is activated it automatically deactivates as soon as the readings go back within the threshold. Setting alarm hold means the alarm stays active even when readings return to normal, so you can see that a problem occurred even if it is now OK.
Click this link and choose either the App Store or Google Play to download the EasyLog Cloud app.
If your EL-IOT loses its connection to the WiFi network, it will carry on logging data, and as soon as the connection is restored the data will be automatically uploaded to the Cloud.
EL-IOT is not supported by Android 4.4 and below, and therefore will not be shown as an option to set up on the EasyLog Cloud app.
EL-IOT is not supported by iOS 12 and below, and therefore will not be shown as an option to set up on the EasyLog Cloud app.
Once the new EL-IOT firmware update has been selected, the update will begin on the next Cloud sync.
A ‘low battery’ message is shown while the power supply is in use. When batteries are used instead of the power supply, the battery icon will accurately display the battery life.
Please see the accessories linked on the EL-IOT product page or alternatively, follow the link to the ‘EL-IOT WALL BRACKET‘
We recommend you send your EL-IOT for calibration on an annual basis, but you can do this more frequently if you prefer.
EL-WIFI – When the sensor is displaying the main reading screen on the LCD, press the button on the front three times. The MAX, MIN and Signal Strength screens will be quickly displayed. The device will try to transmit its latest data immediately, regardless of the transmission rate setting.
EL-IOT – You must hold the main button on the device for 1-8 Seconds. This acknowledges an alarm, creates an audit event in the record, and forces data synchronization with the Cloud.
EL-WEM – As the EL-WEM has a fast update rate by default, there is no way to force transmission with the cloud.
IT IS RECOMMENDED THAT YOU ARCHIVE THE DEVICE ON YOUR EASYLOG CLOUD DEVICES PAGE BEFORE UNDERTAKING A FACTORY RESET.
EL-WIFI – The device can be reset by holding the button for 10 seconds. Release the button when RST appears on the screen. The device will retain all settings but will lose any data that had not been transferred to the EasyLog Cloud. It will continue to be connected to the account it was set up with and will simply start a new recording session.
If necessary, a full factory reset can also be performed by holding the button for 20 seconds until FArS appears on the screen. Doing this will return the device to the factory state, deleting all settings and clearing any remaining data. The device will no longer be connected to any network or EasyLog Cloud account.
EL-IOT – To reset the device, you must remove the battery cover with a screwdriver. Once removed, there is a reset button that can be pressed using a pin. Hold this button for a few seconds until the device beeps.
EL-WEM – To soft reset the device, there is a reset button on the bottom of the base. Press the button and release after 1 second.
To factory reset the device, hold the same reset button for 5 seconds.
